![]() Read hostnames or addresses from the specified file instead of from the command line. See the description of the option for details. The alphabetic hex characters may be either upper or lower case. arpsha=01:23:45:67:89:ab.īinary data specified as a hexadecimal string, which should not include a leading 0x. arppro=2048 or -arpro=0x0800.Ī floating point decimal number, e.g. file=hostlist.txt.Īn integer, which can be specified as a decimal number or as a hexadecimal number if preceded with 0x, e.g. The letter indicates the type of data that is expected:Ī character string, e.g. Note: where an option takes a value, that value is specified as a letter in angle brackets. These different options for specifying target hosts may be used both on the command line, and also in the file specified with the -file option. 192.168.1.3-192.168.1.27) to specify all hosts in the inclusive range, or IPnetwork:NetMask (e.g. 192.168.1.0/24) to specify all hosts in the given network (network and broadcast addresses included), or IPstart-IPend (e.g. You can also specify the target as IPnetwork/bits (e.g. The target hosts can be specified as IP addresses or hostnames. ![]() ![]() You will need to be root, or arp-scan must be SUID root, in order to run arp-scan, because the functions that it uses to read and write packets require root privilege. Target hosts must be specified on the command line unless the -file option is given, in which case the targets are read from the specified file instead, or the -localnet option is used, in which case the targets are generated from the network interface IP address and netmask.
0 Comments
Leave a Reply. |